About this deal
The remote control feature can be set up with as many devices as you like, just as long as your phone or tablet is connected to the same home network as your Virgin TV V6 or TiVo box. Insert the batteries into the Virgin remote and test whether the remote works. Power Cycle the Virgin Media Receiver
These remote types can be programmed to control your TV Volume. Simply look up the 4-digit codes for your make of TV from the list here, then follow the instructions below. Loverly polite lady, I briefly explained what I’d done, said I’d replaced battery, tried holding down TV and rewind for ten secs, followed by TV and zero. Profiles – families can now create their own profiles so that they can control their own pause points, select their favourite channels and receive personalised recommendations. If the previous step has not worked, try the factory reset on your remote. This is done by holding down the TV and the rewind buttons at the same time. The rewind button is the one with the double arrow facing left toward the bottom of the remote.Or in some cases, it might be down to the box itself, which can be resolved by simply restarting it. If you restart it and it helps, but then after a while it continues to struggle with connection, then the issue is with the remote itself, and you’ll want to get yourself a replacement. You may find that your remote has not automatically connected to your tv and the box after setup. If this happens it does not mean there is anything wrong, you will just have to do a little bit more to get it ready for pairing. To connect your virgin remote with your tv when this happens take the following steps:
Lenson, Matsui, Medion, Metronic, Micromaxx, Microstar, Movie Time, MyStar, Nikko, Noos, Now Broadband, NSCFirst, point your remote at the box while holding the TV button and the zero button for ten seconds. The TV button is located towards the top on the right side of the remote. The zero button is at the bottom center of the remote. If you reach the end of the code database, the light on top of the remote will give an extended red flash and exit programming mode.