Joined in 2023 
82 
63 About this deal
May vary due to local conditions) Latency 2.3 ms Dynamic Range 110 dB or greater Frequency Response 20 Hz--20 kHz Nominal Output Level -10 dBu Output Impedance 1 k ohm Recommended Load Impedance 10 k ohms or greater Indicators POWER To charge the transmitter, the receiver must be powered via a BOSS PSA-S adaptor. It’s also possible to directly charge the transmitter with a standard USB adaptor (5 V/500 mA or higher). I bought this because the WL-20 and the WL-20-L were not available. I do not regret it! I use it at home and in the rehearsal room, to get rid of the guitar cable. I was fed up getting my feet caught every time in the cable - now with the WL-50 it feels so good. Instead of the little dongle on the amp side (WL-20), I have now the small WL-50 box (even if I do not use a pedal board) standing at the side of the amp, with a 1 m cable to connect the box to the amp. To recall: the "Input" connector is only used when you connect the guitar by cable and do not use the wireless. While charging transmitter: 320 mA Expected battery life under continuous use Alkaline battery (AA, LR6): Approximately 7hours oz Specifications (TRANSMITTER (WL-T)) Nominal Input Level -10 dBu (1 M ohm) Indicator BATTERY Connectors Input plug: 1/4-inch TRS phone type
Charging simultaneously with the transmitter: Approximately 4 hours Expected battery life under continuous use Approximately 7hours With the WL-50, it’s never been easier to bring wireless freedom to your pedalboard. Driven by new BOSS technology, the WL-50 delivers premium sound and a plug-and-play experience that eliminates all the hassles normally associated with wireless systems. Supplied from the DC IN 5 V port Current Draw 350mA Battery charging time Approximately 3 hours Expected battery life under continuous use Approximately 12 hours With cable tone on the “short” setting, the cable tone simulation reproduces the tone of using a 10 foot cable. This is the same as the WL-20.
BOSS WL-50 Features:
At street gigs and other mobile performance situations, running your pedals on battery power is often the best choice. The WL-50 receiver can run for up to sevenhours on two AA batteries, allowing you to take your wireless setup with you! While running on battery power, the receiver is unable to charge the transmitter. But don’t worry—you can still charge it using a common USB adaptor (5 V/500 mA or higher), the same type used with most smartphones and tablets. Specifications (RECEIVER) Wireless Format BOSS proprietary digital audio format Wireless carrier frequency 2.4 GHz Compatible Channels 14 Boss says that you’ll get 10 hours playtime out of it, and whilst we’ve not tested the full 10 hours out, we gave it a good play through for a few hours and it remained green the whole time. A WL-20 system is literally as simple to use as a standard guitar cable. The small transmitter plugs into your instrument, while a matching receiver plugs into a pedal or amp. That’s it! Automatic Wireless Setup
Another handy little feature on the transmitter of the WL-50 is that there’s a tiny on/off button that’s depressed when plugged into a guitar input. This means that it’s only active when plugged into a guitar, so you don’t get that nasty pop when you take the transmitter out, as you would do with most traditional cables.
WIRELESS FREEDOM FOR PEDALBOARDS
It can be powered via 9V adaptor or 2 AA batteries for up to 10 hours. If you’re using an adaptor, the WL-50 can be used as a power distribution hub to power other pedals via daisy chain. allow for an elbow joint between the receiver's 1/4 inch input and the body so it can fit more compactly against my fiddle. That'd be freaking awesome, man.
The WL-50 fits snugly into your pedalboardwhere it can charge and provide up to 12 hours of continuous battery life. Setup only takes 10 seconds after plugging in the transmitter, so plug in and play in a pinch.You won't expect any signal drop-outs as the Boss wireless system works in a 2.4 GHz frequency for great audio. Ultra-low latency also prevents a lag between playing and the amp producing sound. Creative design WL-20 also features built-in cable tone emulation, which reproduces the tone of using a 10 foot guitar cable. May vary due to local conditions) Latency 2.3 ms Dynamic Range 110 dB or greater Frequency Response 20 Hz--20 kHz Nominal Input Level -10 dBu Input Impedance 1 M ohm Nominal Output Level -10 dBu Output Impedance 1 k ohm Recommended Load Impedance 10 k ohms or greater Controls CABLE TONE switch (OFF/SHORT/LONG) Indicators POWER
It’s very much plug and play – to pair, simply plug the two together, wait for the yellow light to stop flashing, and you’re ready to go. The unit’s auto-pairing feature automatically chooses the optimum frequency to operate on in any given room out of the 14 possible channels.
The easiest introduction to the world of wireless systems, WL-20 consists of a bug style transmitter and corresponding receiver, with a nominal operating range of 15m. This can be an issue with low-end digital wireless units, which typically only have 3-4 channels to choose from. If these channels happen to be very heavily in use, then you may experience severe dropouts and interference when you least expect it.Cable tone simulation reproduces the natural capacitive effect of a 10-foot/3-meter guitar cable (WL-20 model only) Have you always dreamed about going wireless with your instrument, but were put off by the complicated setup, tone loss, and bulky adds-ons? If so, the WL-20 series is for you! Driven by new lightning-fast BOSS tech, these ultra-compact music tools deliver premium sound and plug-and-play operation that completely eliminates all the hassles normally associated with wireless systems.
Great Deal 
New Comment