Sentinel - X800 Fast Acting Cleaner 1L, targeted central heating system cleaning inside an hour, restores system efficiency by targeting corrosion debris, ideal for hot and cold systems

Product Information

The circulation pump of the system can be used to circulate the cleaning solution; however equipment which provides a more rapid circulation can provide a more effective clean. When using an external cleaning rig, the product can be dosed directly to the buffer tank of the rig (follow equipment manufacturer’s instructions). When using concentrate gel, add directly to the heating system either via a radiator air bleed valve, or via the fill loop using the appropriate adaptor and a suitable caulk gun. it's not cheap for a can of "liquid", but I suppose if it's got lots of magic in it then it's quite cheap! continue to flush through with fresh water until water runs clear without sediment. catch some in the palm of your hand, you will see small bits easier.

Sentinel - X800 Fast Acting Cleaner 1L, targeted central Sentinel - X800 Fast Acting Cleaner 1L, targeted central

X800 Fast Acting Cleanershould be circulated, preferably at normal operating temperature, with all valves open and the pump turned to maximum flow for a minimum period of 3 hours or until satisfactory performance is restored. What is the best product to get rid remove corrosion/magnetite sludge? Is Sentinel X400 more appropriate than X800? What is the difference between both products?

Product manuals and instructions: filter and scale protection

Sealed Systems: If the system is empty, add to any convenient point before filling. If full, use a Sentinel Dosing Vessel to inject via the filling loop or other access point. When you drain the X800, do you refill the system with plain water and drain it again to drain away any remaining loosened dirt? It is recommended thatX800 Fast Acting Cleaneris used in accordance with standard cleaning and commissioning protocols such as BSRIA Guide “Pre-Commission Cleaning of Pipework Systems”. Our detailed product safety sheets contain all the information you need to know about our chemicals, including:

Product Facts

If your system does not have a filter,then first job would be to fit one,Magnaclean Pro 2 among the best & easiest to fit, the filter will collect any crud dislodge by the cleaner. Actually I should be fine, did not know the difference between single and double feed cylinders (//www.diynot.com/forums/viewtopic.php?t=206316). I need to clean my central heating system due to corrosion/magnetite sludge producing excessive hydrogen (did the test with the match which confirmed this was hydrogen).

Thanks again Tony, all my radiators are quite recent (apart from one), had them upgraded around 3 years ago. Hopefully they should hold. Sentinel X800 Fast Acting Cleaner is a heavy-duty cleaner for small or large commercial heating and closed-circuit cooling systems. It is formulated to penetrate and remove iron oxide and calcium based deposits from the entire circuit, including boilers, heat exchangers, radiators and pipe work. It is ideal when systems require immediate, unplanned cleaning. i have used x800 without a powerflusher, used it for a over night cleaning of rads, eg run the system over night then i come the next day to change the boiler.