About this deal
This is a durable, hard-wearing safety trainer which borrows a few protection and construction ideas from larger work boots. Meets ASTM 2413-11 I/75 C/75 for protective toe impact and compression and EH properties with electrical hazard protection, keeping you protected on site. While kitted-out similar to many full-fledged work boots, the Cutter very much wears and looks like trainers. The most common location for reinforcement is over the toe cap, along the metatarsals, and right behind the heel.
If you need a certified work shoe that does away with bulk and discomfort, a DeWALT safety trainer is the way to go. Please include what you were doing when this page came up and the Cloudflare Ray ID found at the bottom of this page. While the DeWALT Plane is a low-cut safety trainer, it has protections to rival many full-sized work boots.If a refund is payable to you we will process the refund as soon as possible, and, in any case within fourteen (14) days.
However, they went a step further, including a composite midsole plate to guard against sharp objects piercing underfoot. The choice of composite for the midsole protection was similarly a good one, as it flexes with your foot whilst offering superior stability and support. Instead, they put their products through the certification process, allowing them to bear CE marks and ship with paperwork to satisfy workplace requirements. These materials usually bear the same rating as their steel counterparts, but greatly reduce weight and discomfort within the shoe. The Crossfire Mid’s outsole is slip resistant, and repels the intrusion of harsh fuel oils which would otherwise degrade the rubber (or your feet, besides).That said, it can be a bit of a chore to keep it looking smart, as dirt likes to dwell stubbornly in the mesh. This is not only a more flexible option, but more durable as Kevlar will dutifully hold your laces fast without warping or snapping.