Polycell Crack-Free Ceilings Smooth Matt 2.5L

Product Information

Now that you’ve stripped the peeling paint and carried out what’s necessary to action, it’s time to apply your fresh paint. Be sure to give it two coats of paint for best results. Paint flaking can occur with a number of different factors. Most commonly, improper application to the wall and too much hard grain is used. Start by cleaning debris away from the area and allowing it to dry thoroughly. Use Polyfilla EasySand5 or Universal Ready Mixed Filler to fill the hole. This is caused usually by a wearing away of the paint film by weathering or could be evidence of salts coming out of the surface. Putting it right

You will need to rub down using 'wet and dry' abrasive paper using water with a little detergent added. The surface should then be rinsed and allowed to dry before repainting. If this is impractical due to the size of area affected the area could be horizontally lined with lining paper and then repainted. When you remove the rail, it will probably leave holes where the nails or screw used to be. Fill these with lightweight filler such as Polycell No Sanding Polyfilla. You... Read the full answer... 4 Are things like brush cleaners really necessary why not just use white spirit?Adding a second coat of paint will get rid of streaks left by rollers. You can make the job more seamless by taking a brush and going over the streaky areas to smooth out. When the surface is thoroughly dry the affected surface will need to be rubbed down using 'wet and dry' abrasive paper. It can then be re-coated. Due to time & dust issues (2 kids to think about) I will probably go to a plasterer for the rest downstairs but it has been an interesting project (apart from the peeling paint bit) However, if you need your project done faster, special fast-drying versions can be ready within 15 minutes or less. If you’re unsure how long it will take for your particular application of Polyfilla to dry completely, read the product instructions carefully before beginning work.

Make sure that all filled areas are rubbed down smooth and level. You will need to prime the filler before painting to prevent subsequent coats being absorbed more rapidly than on other areas. Use a coat of Dulux emulsion thinned 10-20% with clean water. Once this is dried you can apply a full coat of Dulux emulsion. It is important to seal the original stain by applying a coat of Polycell Stain Stop prior to re-decorating. The first job is to sand them with a coarse grade of sandpaper to get off the worst of the lumps and bumps, followed by a medium grade sandpaper. Next,... This is caused by painting over contaminated surfaces such as wax, oil or polish. The paint cannot adhere to the surface and draws away leaving unpainted areas. This can also be caused by contamination on the brush. Putting it right Additionally, ensure that all surface dust is removed so that it does not interfere with the adhesion of the applied layers. Can you Apply Polyfilla with a Brush?

This is usually caused by contamination of the underlying surface by soluble stains. Putting it right

Sand the surface: Once the Polyfilla has dried, use 120 fine-grit sandpaper to smooth out rough spots.My house is nearly 70 years old & I initially went down the smoothover route as I had the whole house to do and the walls were in very good condition apart from a few digs & scrapes as it was a well kept one owner house with only one layer of wall paper & the original ceiling paint underneath. The Polyfilla must be kept from direct sunlight in a cool and dry place with temperatures under 70°F (21°C). To further help maintain the product’s lifespan, make sure that the lid is properly sealed after each use