About this deal
To maintain the overall finish and its anti-slip properties of cuprinol decking stain, re-apply a fresh coat of Cuprinol Anti-Slip Decking Stain when the surface starts to show signs of wear. Any areas that have been affected by mould or mildew, should be treated immediately with a suitable mould and mildew cleaner. If using more than one can, it is advisable to mix them together in a larger container or finish in a corner before starting a new can to ensure colour consistency.
Cuprinol recommend allowing 7 days after application before subjecting the surface to foot traffic or placing furniture - this is to allow the product to fully cure. To maintain the surface finish and its anti-slip properties, re-apply a fresh coat of Cuprinol Anti-Slip Decking Stain when the surface starts to show signs of wear, following the Preparation and Application instructions above. To begin, stir the decking stain thoroughly, and then apply 2-3 coats evenly along the grain, avoiding any overlaps where possible.Do not apply in temperatures below 5C, in damp conditions or if rain is likely before the product has dried. Apply in dry conditions, above 5 degrees Celsius and when bad weather is not forecast, minimum of 2 coats required. This matt wood paint from the Cuprinol Garden shades range is the perfect choice to refresh your home exterior. To avoid difficulties it is good practice to acknowledge how much time you can commit to a project in one straight run and not to attempt too much; Divide the task into hourly chunks and paint the first coat on a section of the project, perhaps one or two sides of the shed.
If using more than one can it is advisable to mix them together in a larger container or finish in a corner before starting a new can. On decking previously stained with Cuprinol Anti-Slip Decking Stain, use a wire brush to remove any loose or peeling material and remove any surface contaminates as mentioned above. We’ve written a blog about things to consider when laying a new deck, how to treat different types of decking and some best practices for when applying a finish. Before full application of cuprinol decking stain, we always recommend testing out a small area on your decking surface to ensure you are happy with the products overall adhesion and finish. Cuprinol Decking Stain colours your decking with a tough, durable, water-repellent, protective coat that resists cracking and peeling caused by weather.Any overspray should be cleaned up immediately (whilst still wet) with water and household detergent. Most purchases from business sellers are protected by the Consumer Contract Regulations 2013 which give you the right to cancel the purchase within 14 days after the day you receive the item. If wood has been exposed and dried out for a long period of time, this may also draw the more of the product away from the surface and into the wood structure. If you come across any holes or gaps on your wooden surface, these should also be filled in before starting. It is free-flowing to enable a smooth finish that gets into all the gaps and allows the profile of the wood to be a maintained.
If any product is defective in any way or has a fault within 90 days of purchase, a full replacement or refund will be made at no charge. It has a coverage of up to 8m 2 per litre with 2 coats on bare or previously stained wood, and a drying time of 2-6 hours depending on the nature of the surface and the weather conditions.Providing an overall rich and transparent colour, it features long lasting weather protection, whilst also providing coverage of up to 12 sq m per litre and can be easily applied with either a brush or roller. Special pigments ensure a rich colour and allow the natural texture of the woodgrain to shine through. As Garden Shades often goes on directly to the wood, without a primer, sometimes it will soak deep into the wood and this can create the need for a third coat.