Nerf N-Strike Elite Jolt Blaster

Product Information

However, because the Nerf Jolt is only a toy the seal on the plunger which prevents air from escaping out of the chamber when the trigger is pulled is not completely air tight. As the air escapes out of the chamber, most of your power to propel darts over a further distance disappears too!

This creative mod is completed by hooking a rubber band on the top of the blaster down to the plunger. When the trigger is pulled, the blaster will now have more force propelling darts forward. If the spring upgrade mod is not a feasible option at the moment, then this mod is another suitable choice to improve your blaster’s power.With only a little bit of work you have increased the power of your Nerf Jolt by 15 feet per second from its original firing power. It really is as simple as that!

Alpha Trooper CS-18 • Barrel Break IX-2 • Barricade RV-10 • Deploy CS-6 • LongStrike CS-6 • Rapid Fire AS-20 • Spectre REV-5 • Stampede ECS

Conclusion

Surprisingly, second place for the range assessment was given to the Nerf Rival Roundhouse XX-1500 Blaster— the model that uses foam balls as a projectile rather than darts. The furthest ball we recorded traveled a distance of 88 feet. It's even more impressive that this is a manually powered toy blaster that is not that hard to set. The Roundhouse gets the thumbs up from the GearLab crew. If you are deep in a toy blaster clash, it's nice to have extra projectiles ready to go. We considered the number of darts or foam balls that each model has loaded and ready or ready to load.

To start this method of making the SuperJolt, all you need to do is grab the dart post with your pliers and twist! The dart post should break off fairly easily. Next, you take your screwdriver and place the tip of it down the barrel against the air restrictor. Break the air restrictor off with a few good taps and shake any extra pieces out of the barrel.

Our Top Picks

Of note, models based on the original version of the Jolt has a screw in the plunger tube; later revisions, starting with the 2013 blue Jolt, use a nail instead. While there are plenty of do it yourself Nerf Mods, Nerf also sells its own attachments to improve the performance of their blasters. With tons of attachments to choose from, you may not know which ones will best benefit your blaster. Because there is not much you can do inside your Nerf Jolt to improve its performance, you will need to optimize the exterior of the blaster instead. However, due to the smaller size of the Nerf Jolt there was not room for any tactical rail or attachment spots.

The Jolt has had many re-releases with alternate color schemes. It has also been used as the basis for other blasters, which are often referred to in the community as "Jolt re-shells". Some "Elite repaint" variants of the blaster use the Zombie Strike mold, and have the Zombie Strike logo on the side even though the blaster itself is an N-Strike release. The simplest method for this mod takes only a matter of minutes and only requires a screwdriver and some needle nose pliers.However, because of this blaster’s smaller size and the challenges the Nerf Jolt poses in modifications it is very popular for Nerfer’s to try to conquer the Nerf Jolt by creating successful mods. Keep collections to yourself or inspire other shoppers! Keep in mind that anyone can view public collections - they may also appear in recommendations and other places.