About this deal
To minimize confusion, it is best to describe a connector using: the manufacturer's name, exact connector series, and optionally the pitch, such as "JST-XH" or "JST-XH-2.50mm" or "2.50mm JST XH-series" or other variations. a b "List of JST connector series; JST". Archived from the original on 2020-11-12 . Retrieved 2013-08-31.
The fully shrouded header has walls on all four sides to prevent improper connection to the mating housing and to prevent the intrusion of flux and other contaminants. Your male connector also has two small lumps/keys then correspond to the two small holes either side of the long slot on the female. The solder side of the header has a retention mechanism that prevents it from floating during soldering. As a result, the header can be positioned accurately.JST France, electronic components manufacturer, was established in Vitry-le-François in 1989. Our plant is composed of 3 machine shops (molding, assembly and stamping) and an industrialization Very similar to the above series, however in a dual row configuration. Commonly used in LCD / LVDS applications. GH (1.25mm pitch)
This 2.0mm pitch connector is very commonly seen in low cost consumer electronics as well as a plenitude of pre-fabricated hobbyist PCBs and parts. They’re dirt cheap, reasonably compact but not particularly robust.The WC-240 is nice to use, but there’s not a lot to set it apart from generic tools for occasional use. I personally crimp a large amount of PH, hence the investment in the official tool. Choosing the Right JST Connector". DronesEtc. Archived from the original on 4 March 2016 . Retrieved 13 August 2015. Your male connector has a bar down the center, which corresponds to the long slot in the middle on the female connector. We recommend you own a set of crimping pliers as well, such as these nice ones from Engineer - they're easier to use than trying to crimp with pliers.